Technical Features - RIB PARK CRX 120V Bedienungsanleitung

DIP 12 - Controlling RAPID S, RAPID N, RAPID PARK series bars slow-down.
OFF - Operation control with low speed limit switches connected separately (see photo
5) FIXED ON THE SPRING HOLDING BALANCE.
ON - Operation control with low speed limit switches connected in parallel (see photo
6) LIMIT SWITCHES FIXED ON THE DRIVE SHAFT.
OFF - Operation control with low speed limit switches separately connected (see photo
7). LIMIT SWITCHES WITH CONTROL PANEL.

TECHNICAL FEATURES

- Temperature range
- Humidity
- Power supply voltage
- Frequency
- Maximum card absorbtion
- Network microswitch
- Barrier open warning light maximum power
- Maximum power at blinker output
- Voltage available for photocells and accessories
- Voltage available on the radio connector
RADIO TECHNICAL FEATURES
- Reception frequency
- Impedance
- Sensitivity
- Excitation time
- De-excitation time
- Codes in store
- All the inputs must be used as clean contacts given that the power supply is generated
internally (safe voltage) in the card and it is set in a way to guarantee the use of the
double insulation and reinforced compared to parts with hazardous voltage.
- Any external circuits connected to the outputs of the control board, must be carried
out to make sure the double or reinforced insulation is used compared to parts with
hazardous voltage.
- All the inputs are run by a programmed integrated circuit which carries out an auto-test
at every start-up operation.
-10 ÷ + 55°C
< 95% without condensation
230 or 120V~ ±10%
50/60 Hz
30mA
100ms
3 W (equivalent to 1 lamp of 3W
or 5 leds with 2.2 KΩ resistance in
series)
40W with resistive charge
500mA 12Vdc
200mA 12Vdc
433.92MHz
52 Ω
>2.24µV
300ms
300ms
N° 60
27
G
B
5
6
7