Herunterladen Inhalt Inhalt Diese Seite drucken

Panasonic AK-HC1500G Bedienungsanleitung Seite 20

Vorschau ausblenden Andere Handbücher für AK-HC1500G:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 68
How to install
 Example of mounting the camera onto a bracket or tripod made by
another manufacturer
Notes
 When installing the mounting bracket or attaching one end of the drop-prevention wire
to the ceiling or a wall, be absolutely sure to use the anchor bolts, and ensure that the
withdrawal strength of the installation surface is at least ten times the total mass of all units
installed, including the mounting bracket, camera, lens, and cables.
 When the camera has been attached to a tripod as well, be absolutely sure to prevent the
camera from falling off by using the screw in the tripod or other such means.
 Ensure that the total mass, including the mounting bracket, camera, lens and cables, does
not exceed 8 kg (17.6 lbs.).
 Ensure that a drop-prevention wire is installed in such a way that the drop distance does
not exceed 150 mm.
 Tighten the mounting screws using the torque levels shown in the table to the below,
and then check for play and
unsteadiness.
 Do not use an impact driver as doing so may cause damage to the screws.
Be sure to ask the dealer for the installation,
adjustment and connection of this equipment.
Mounting screw for wire
(Inch screw: 1/4-20UNC) (supplied)
Secure the end of the wire onto the M6 or M4 anchor bolts by
tightening nut or secure it by tightening the M6 or M4 bolts.
Drop-prevention wire (sold separately)
Spring washer (supplied)
Flat washer (supplied)
Camera mounting screw holes
Bracket or tripod made by another manufacturer [*]
When using inch screws (1/4-20UNC), drill
holes with a 7 mm diameter (see page 12).
Flat washers [*]
Spring washers [*]
Mounting screws [*] (Inch screws: 1/4-20UNC)
Camera mounting screw holes
When using inch screws (3/8-16UNC), drill
holes with a 10 mm diameter (see page 12).
Flat washers [*]
Spring washers [*]
Mounting screws [*] (Inch screws: 3/8-16UNC)
Screws
Mounting screws (1/4-inch screws)
Mounting screws (/8-inch screws) 1 N • m (10 kgf • cm)
- 19 (E) -
[*]: Procured locally
Clamping torque
.0 N • m (0 kgf • cm)

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis