Panasonic AK-HC1500G Bedienungsanleitung Seite 11

Precautions for installation
Be sure to ask the dealer for the installation, adjustment and connection of this equipment.
Parts to be provided by the customer for installation
When the unit is to be mounted onto a Panasonic pan-tilt head, use the mounting screws
and drop-prevention wire that are supplied with the pan-tilt head.
Provide the following parts when the unit is to be mounted onto a surface other than a
pan-tilt head.
 Drop-prevention wire* (sold separately): 1
(*Be absolutely sure to use the drop-prevention wire.)
Drop-prevention wires in three different lengths (00 mm, 450 mm and 600 mm) are
available as optional accessories.
Use a wire in the length that will have no slack to suit the installation location and
installation method.
Consult your dealer when you purchase one of these drop-prevention wires.
ø6.5
(Camera side)
ø4.2
Wire length (mm)
00
450
600
 Mounting screws (Inch screws: 1/4-20UNC): 2 (For mounting the camera) or
Mounting screws (Inch screws: 3/8-16UNC): 2 (For mounting the camera)
Determine the length of these screws by factoring
in the thickness of the camera mounting bracket.
 Mounting screws (M6) for installation end wire
At the installation location, be absolutely sure to use the anchor bolts, and ensure that
the strength of the installation surface is at least ten times the total mass of all units
installed.
Wire length (300, 450 or 600 mm)
ø1.2
Parts number
CN001064BAA
CN001064BAB
CN001064BAC
ø6.5
(Installation side)
ø4.2
- 10 (E) -
11 mm
Camera mounting
bracket
7 to 9 mm