Head Fit Headset 5 - look 795 RS Montageanleitung

EN
The LOOK HEAD FIT headset is a system which incorporates several improvements. It makes it
possible to adjust the headset and stem separately. These two functions become independent,
permitting simpler adjustment of the stem and greater precision of the headset adjustment. In
addition, it increases the life of the headset bearings when considerable strain is applied to the
handlebar. Steering fluidity and precision of steering are optimum thanks to the incorporation
of the sheaths inside the upper bearing.
PLEASE NOTE : The headset is factory assembled and adjusted so as to be operative on
first use without first being dismantled. You are strongly recommended to contact your
approved LOOK retailer regarding the complete assembly of the HEAD FIT LOOK headset.
1 Stem elastomer
2 Lock ring
3 Insert
4 Pin
5 Compression ring
Brake sheath retainer screw
5.1
(AEROLIGHT))
6 1½" bearing
7 Pin hole
Front brake sheath ducting
8
(AEROLIGHT)
32

HEAD FIT HEADSET 5

Fig. 11
5
5.1
Fig. 12
1
2
3
4
5
6
7
8