Inserting The Battery And Closing The Battery Compartment Cover; Covering The Headset Connection; Charging Batteries - Auerswald COMfortel M-710 Betriebsanleitung

Initial Commissioning
2. Press the unlocking key (D).
3. Disconnect the flat connector (A).

Inserting the battery and closing the battery compartment cover

Warning: Using unapproved rechargeable batteries or normal batteries
can cause serious harm to health or damage to equipment, and also
functional faults or damage to the device. The casing of rechargeable
batteries can be destroyed, or rechargeable batteries can explode.
• Only use rechargeable batteries that suit the device's technical data.
E
1. Insert the rechargeable batteries with +/- alignment as shown in Figure E.
2. Place the rechargeable battery cover on from above on (Figure F).
3. Slide the cover to close it, until it clicks in place.
If you need to open the rechargeable battery cover again, to replace the
rechargeable batteries:
• Place your fingernail in the groove on the cover and slide the cover down
(Figure G).

Covering the headset connection

1. Insert the tab on the rubber cover for the
headset connection in the opening on the
left-hand side of the handset.
2. Press the rubber cover on.

Charging batteries

• Before you use the handset for the first time,
put it in the charging cradle and fully charge
the rechargeable batteries.
The rechargeable batteries are fully charged
when the lighting flash symbol
Caution: The handset must be charged in the charging cradle supplied
with it!
30
F
goes out in the display.
COMfortel M-710 - Instructions V01 06/2021
G