ANATOMICAL BACK
L
L
L
L
LEG SUPPORTS
Downloaded from
www.Manualslib.com
(OPTIONAL)
Use suitable tools (a Phillips screwdriver).
Check that the backrest is secure before use.
Avoid getting your fingers caught during the assembly process.
Avoid damaging the screws / washers.
manuals search engine
Your wheelchair will normally be supplied with a flexible,
padded backrest. To use the anatomical backrest, proceed
as follows:
Unscrew the flexible backrest.
•
Loosely screw on the brackets for the backrest.
•
Insert the backrest into the brackets from above.
•
Tighten the screws holding the brackets for the
•
backrest.
Insert and tighten the safety screws for the
•
backrest.
Add the armrests (see "Armrests" chapter).
•
Removing the leg supports
First remove the calf strap by unhooking it on
1
both sides.
Push back the lever near the leg support
2
attachment.
Now you can swing the leg support to one side
3
and lift it out of the pins.
L
Keep objects and people away from the leg
supports' swing range.
Attaching the leg supports
Insert the leg supports from the side into the pins
1
located on the frame.
Swing the leg support inwards until the lock
2
automatically stops it (if this lock is a little stiff,
press it gently back).
Now replace the calf strap in the hooks.
3
L
Before use, make sure that the leg supports
are securely locked in place.
L
Keep objects and people away from the leg
supports' swing range.
6
E
708 D
06/2008