Faults, Causes, Solutions - Sentiotec WAVE.COM4 SOUND&LIGHT Bedienungsanleitung

7.0.0 FAULTS, CAUSES, SOLUTIONS

This list shows possible problems, their causes and recommended procedure for resolving
them.
The display of the colour module cannot
be activated
Colour lamp does not light although the
colour operating element shows colour
numbers
The colour of the lamp and the numbers
on the display change but do not
correspond
One colour and its mixed colours are
missing
The colour of the lamp and the numbers
on the display do not change
The colour of the lamp and the numbers
on the display change automatically
Fault Possible cause
Check power supply to the power element. If this is
in order but none of the symbols on the display
lights, then check the data connection of the
colour operating element;
No lamp supply between LED coloured lamp and
LED power element;
Check cables/terminals; and if need be check the
programming (brightness of the individual colours)
Check connection sequence of the connection
between LED coloured lamp and LED power
element
Check terminal wire of the connection between
LED coloured lamp und LED power element and if
need be check the programming (brightness of the
individual colours)
Set to "Automatic" mode;
If need be connect through manually and if need be
check the programming (interval period of the
individual colours)
Set to "Manual" mode;
If need be check programming (interval period of
the individual colours)