Master / Slave Programming - Sentiotec WAVE.COM4 SOUND&LIGHT Bedienungsanleitung

13. The programmed GREEN – portion of the chroma flashes in the display.
14. Changeable with
15. The programmed BLUE – portion of the chroma flashes in the display
16. Changeable with
On completion of all inputs, the control is again in "Manual" mode

4.3.2. MASTER / SLAVE PROGRAMMING

Here you can set to decide whether the operating element is used in the
Single/Master operation
Selection „SIN", (=standard setting,) without Wave.com4 sauna base section as master
Setting for pure colourLEDcontrol without sauna function
or in
Slave operation
Selection „SAU", with sauna base section as Master
Setting for use with Wave.com4 Sauna control
5. Disconnect 4-pin bus/supply cable from the operating element
6. Simultaneous pressing of the
7. Plug in cable again when pressing the key.
8. The display flashes and the mode set for the operating element appears
(SIN or SAU)
5. Set the mode with the
6. Confirm input with the
(see 4.3.5. REMOTE START activate/ deactivate)
and with the MODE
and with the MODE
keys
keys.
key and jump to the "Remote start activation"
key confirm the input
key confirm the input