Programming Functions; Programming Cycle Time - Sentiotec WAVE.COM4 SOUND&LIGHT Bedienungsanleitung

OPERATING INSTRUCTIONS
Volume

4.3.0 PROGRAMMING FUNCTIONS

The following points provide information on the programmability of the LED coloured lamp.
These settings are stored in a power failure-proof manner

4.3.1. PROGRAMMING CYCLE TIME

The coloured lamp automatically changes, with the exception of "Manual" mode, the chroma
when the Cycle time ends. This Cycle time is 5 minutes when delivered. It can be adjusted in
minute steps.
Proceed as follows:
6. On the operating element with the
mode.
7. Press the
8. The programmed cycle time in minutes and the
9. Use the
10. By pressing the
key simultaneously for approx. 3 sec.
key to change the cycle time.
key twice, confirm the input and thus leave the programming.
With Mode key to volume menu.
Volume can be set in stages with +/-
keys (0- 20).
MODE key, go to "Automatic-colour"
symbol flashes in the display.
33/44