Setup And Installation; Installation / Disassembly Of Barn Door And Filter Frame / Cleaning Of Lenses - Cameo F2 FC Bedienungsanleitung

SETUP AND INSTALLATION

Thanks to its four plastic feet, the spotlight can be placed in a suitable location on a flat surface. Install on a crossbeam using the pre-in-
stalled mounting bracket (A) and a suitable crossbeam clamp (available as an accessory). Make sure that the spotlight is firmly attached and
secure it using a suitable safety cable on the designated location on the top of the spotlight (B). The laterally mounted level screw (C) is used
to configure the vertical beam angle.
Important safety information Overhead installation requires extensive experience, which includes calculating the limit
values of the working load of the installation material to be used and regular safety inspections of all installation material and
spotlights. If you do not have these qualifications, do not attempt to carry out the installation yourself; contact a professional
company.
A
C

INSTALLATION / DISASSEMBLY OF BARN DOOR AND FILTER FRAME / CLEANING OF LENSES

Disconnect the device completely from the power mains. To mount or unmount the barn doors and filter frame, please pivot the spring-load-
ed lock pins (D) on the retaining bracket toward the top. Do not forget afterwards to return the retaining bracket back to the original position
so that the lock pins click back into their locked position.
The Fresnel lens (E) and its rubber frame as well as the glass lens behind it (F) can be cleaned by flipping the retaining bracket upwards as
previously described and then drawing the Fresnel lens and its rubber frame upwards out of the retaining bracket. Clean the Fresnel lens
with a moist, lint-free cloth. The glass lens should be cleaned with a special optical cloth. Return the Fresnel lens and glass lens to their re-
spective positions (Fresnel lens in front) and return the bracket mechanism back to its downward position until the lock pins click into place.
D
B
E
F
15