Accessories - voestalpine Böhler Welding URANOS 2700 MTE Betriebsanweisung

3.15 Sockets panel
1 Torch fitting
Permits connection of the MIG/MAG torch.
2 Negative power socket
For connection of earth cable in electrode welding.
Allows the connection of the earth cable in MIG/MAG
and Pulsed MIG/MAG.
3 (HF) Negative power socket
For connection of TIG torch.
4 Positive power socket
For connection of electrode torch in MMA or earth
cable in TIG.
Allows the connection of the device voltage change
(MIG/MAG).
5 External devices (MIG/MAG torch)
6 External devices (TIG torch)
7 Gas fitting
8 Welding polarity change

4 ACCESSORIES

4.1 General (RC)
Operation of the remote control is activated when connected
to the power sources. This connection can be made also with
the system power on.
With the RC control connected, the power source control panel
stays enabled to perform any modification. The modifications
on the power source control panel are also shown on the RC
control and vice versa.
4.2 RC 100 remote control
The RC 100 is a remote control unit designed to manage the
display and the adjustment of the welding current and voltage.
"Consult the instruction manual".
4.3 RC 120 pedal remote control unit for TIG
welding
The output current is controlled from a
minimum to a maximum value (can be
entered from SETUP) by varying the foot
pressure on the pedal surface. A micros-
witch provides the start trigger signal at
minimum pressure.
4.4 RC 180 remote control
This remote control unit makes it possible to change the output
current without interrupting the welding process.
4.5 RC 200 remote control
The RC 200 is a remote control unit designed to manage the
display and the adjustment of all available parameters of the
power source to which it is connected.
4.6 ST... series torches
1 Torch button
53