Rear Panel; Sockets Panel; Accessories; General - voestalpine WF 4000 Smart Betriebsanweisung

E68 Speed limit exceeded
E61 Speed limit exceeded
E69 Speed limit exceeded
E70 Incompatible "WARNING" alarm
E71 Liquid coolant overtemperature alarm

3.15 Rear panel

1 Gas fitting
2 Signal cable input (cable bundle)
3 Power cable input (cable bundle)
4 Positive power socket (MMA)
5 Cooling liquid inlet/outlet
6 Attachment for wire holder tube

.16 Sockets panel

1 Torch fitting
Permits connection of the MIG torch.
2 External devices (Push/Pull)
3 Torch button connection
4 Cooling liquid connection
5 External devices (RC)
(Warning)
(Alarm)
(Warning)

4 ACCESSORIES

4.1 General

Operation of the remote control is activated when connected
to the power sources. This connection can be made also with
the system power on.
With the RC control connected, the power source control panel
stays enabled to perform any modification. The modifications
on the power source control panel are also shown on the RC
control and vice versa.

4.2 RC 100 remote control

The RC 100 is a remote control unit designed to manage the
display and the adjustment of the welding current and voltage.
"Consult the instruction manual".

4.3 RC 180 remote control

This remote control unit makes it possible to change the output
current without interrupting the welding process.
"Consult the instruction manual".

4.4 RC 200 remote control

The RC 200 is a remote control unit designed to manage the
display and the adjustment of all available parameters of the
power source to which it is connected.
"Consult the instruction manual".
53