Operation; Turning On/Off; Vacuuming Windows; Cleaning And Care - Silvercrest SFR 3.7 D3 Montage-, Bedienungs- Und Sicherheitshinweise

Wipe over the sprayed areas with the wiper 4 .
Loosen stubborn dirt .
˜ Turning on/off
Turning the product on: Press
lights up blue .
Turning the product off: Press
blue light goes off .
˜ Vacuuming windows
NOTES:
Do not hold the product upside down . Do not
move the product sideways .
The maximum capacity of the dirt water container
8 is 270 ml . Stop operation when the MAX
marking of the dirt water container is reached .
Turn on the product .
Move the blade of the vacuum attachment 1
slowly from top to bottom .
When the MAX marking on the dirt water
container 8 is reached, turn off the product .
Empty the dirt water container 8 before further

operation .

NOTE: To empty the dirt water container 8 ,
pull it out from the motor unit 9 first . Remove
the protective cap . Then, empty the dirt water
container .
˜ Cleaning and care
m
DANGER! Risk of electric shock! Before
cleaning: Always disconnect the product from the
charger 2 .
m
WARNING! Do not immerse the product's
electrical components in water or other liquids .
Never hold the product under running water .
Do not use any abrasive, aggressive cleaners
or hard brushes to clean the product and its
accessories .
Cleaning the vacuum attachment 1 , wiper
4 and motor unit 9
10 .
10 again . The
Cleaning the water container 6 , dirt water
container 8 and suction head 12
Cleaning the microfiber covers
The microfiber covers 3 can be cleaned in a
washing machine and in a dry cleaner .
˜ Troubleshooting
Problem
The product is
not working
Streaks keep
appearing
during
vacuuming
Wipe down the parts with a slightly damp cloth .
Do not let any water or other liquids enter the
product interior .
After cleaning: Let all parts dry completely .
Rinse the parts in water and/or mild detergent .
After cleaning: Let all parts dry completely .
Clean the microfiber covers 3 with a mild
setting, up to 60 °C .
After cleaning: Let the microfiber covers 3 dry
completely .
Solution
Charge the product .
Remove the blade by pulling
it sideways from the vacuum
attachment 1 . Moisten the
blade on the round end with
water and/or detergent .
Pull the blade back into the
vacuum attachment .
Use less detergent while
cleaning the window .
GB/IE 19