Before First Use; Assembly; Product Assembly; Attaching The Wiper - Silvercrest SFR 3.7 D3 Montage-, Bedienungs- Und Sicherheitshinweise

Store the product in a cool, dry
place, protected from moisture
and out of the reach of children .
Protect the product against heat .
Do not place the product close to
open flames or heat sources such
as stoves or heating appliances .
˜ Before first use
Remove all packaging materials . Check if all
parts are complete .
NOTE: The product's built-in battery is not
charged on delivery . Charge the battery
completely before first use (see "Charging the
product" section) .
˜ Assembly
˜ Product assembly
Push the vacuum attachment 1 onto the suction
head 12 .
Place the assembly on the motor unit 9 .
˜ Attaching the wiper
NOTES:
Prior to assembling the wiper 4 , fill the water
container 6 with water and/or cleaning
detergent .
Do not use abrasive or aggressive cleaning
detergents . These could damage the product .
Do not exceed the water container's 6 maximum
capacity of 360 ml .
Screw the wiper 4 onto the water container 6 .
Unfasten the hook-and-loop strap on one side of
the microfiber cover 3 .
34 GB/MT
Place a microfiber cover 3 on the wiper 4 .
Fasten the hook-and-loop strap of the microfiber
cover 3 .
˜ Operation
˜ Charging the product
NOTES:
Before charging the battery: Switch off the
product .
Connect the plug of the charger 2 to the
charging socket 7 .
Connect the charger 2 with a suitable wall
outlet . 10 lights up red .
When the battery is fully charged,
up blue .
On/off button light pattern
Light 10 Status
Blue on
Red on
Red flashing (slow) Low power level . The
Red flashing (fast)
Close the charging socket 7 with the stopper 7 .
˜ Cleaning windows
Rotate the spray nozzle 5 to the desired setting:
Spray nozzle
STREAM
Jet stream .
SPRAY
Water mist stream .
OFF
No stream .
Spray the window .
10 lights
Power on . Fully charged
(when charging) .
Charging .
product keeps operating .
Battery empty . The product
turns off after 1 minute .
5