Operation; Filling/Draining The Water Tank; Steam Smoothing Curtains And Upholstery; Stop Steam Smoothing - Silvercrest SDMF 1630 A1 Bedienungs- Und Sicherheitshinweise

While steam smoothing: The clothes absorb
¾
moisture . Allow the clothes to dry completely
before storing them in your wardrobe .
Continuous steam operation
During continuous operation, hot steam exits out
of the steam nozzles 2 without the need to keep
pressing in 4 .
Continuous steam operation
Start Press in
continuous lock 4 .

operation

Stop
Move up the lock 4 .
continuous
operation
If water drips out of the steam nozzles 2 : Pull
¾
up the lock 4 . Release
heats up now .
˜ Steam smoothing curtains and
upholstery
Remove creases and wrinkles from curtains and
¾
upholstery by hanging these over a railing and
then tightening them .
Before steam smoothing: Always carry out a test
¾
on an inconspicuous piece of the fabric .
Steam the curtains/upholstery (see "Steam
¾
smoothing clothes") .
When using the product horizontally: Hold the
¾
product vertically from time to time to maintain
the maximum steam power .
˜ Stop steam smoothing
Move up the lock 4 , if applicable . Release
¾
4 .
Place the product, with its base 7 , on a flat and
¾
stable surface .
Disconnect the power plug 9 from the power
¾
socket .
22 GB/IE
4 . Move down the
4 .The products
Let the product cool down (for approx .
¾
15 minutes) . Do not leave the product
unattended while it is still hot .
Empty the water tank 6 after each use to
¾
prevent limescale (see "Filling/draining the
water tank") .
˜ Cleaning and care
DANGER! Risk of electric shock! Before
cleaning or maintaining the product: Disconnect
the power plug 9 from the power outlet .
m
WARNING! Do not immerse the product's
electrical components in water or other liquids .
Never hold the product under running water .
Wipe down the product with a slightly damp
¾
cloth .
Do not use any abrasive, aggressive cleaners or
¾
hard brushes to clean the product .
Let all parts dry completely after cleaning .
¾
˜ Descaling
Use a commercially available descaling agent .
¾
Mix a solution of descaling agent and water .
¾
Fill the solution up to the MAX marking 8 in
the water tank 6 . Insert the water tank into the
product .
Let the solution work according to the instructions
¾
of the descaling agent's manufacturer .
Connect the power plug 9 to a suitable power
¾
outlet .
Wait until the product has reached its operating
¾
temperature (the LED 1 lights up permanently) .
Let the steam escape over a sink until no debris
¾
or dirt is left .
Disconnect the power plug 9 from the power
¾
socket .
Empty the water tank 6 . Rinse the water tank
¾
with clear water .