Herunterladen Inhalt Inhalt Diese Seite drucken

Installing A Dimm - Hewlett Packard Enterprise ProLiant BL460c Gen9 Server Blade Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Installing a DIMM

CAUTION: To avoid damage to the hard drives, memory, and other system components, the
air baffle, drive blanks, and access panel must be installed when the server is powered up.
CAUTION: To avoid damage to the hard drives, memory, and other system components, be
sure to install the correct DIMM baffles for your server model.
Power down the server blade (on page 14).
1.
Remove the server blade (on page 15).
2.
Place the server blade on a flat, level work surface.
3.
Remove the access panel (on page 15).
4.
If installing processor 1 DIMMs, remove the mezzanine assembly
5.
assembly" on page 20).
If installing processor 1 DIMMs number 5-8, remove the FlexibleLOM.
6.
If DIMM installation requires removing the right DIMM baffle, do the following:
7.
If installed, remove the direct connect SATA cable
a.
page 19).
If installed, remove the internal USB drive. To locate the internal USB connector, see "System
b.
board components (on page 11)."
Remove all DIMM baffles
8.
Install the DIMM.
9.
Install all DIMM baffles
10.
If removed, install the direct connect SATA cable
11.
19).
If removed, install the internal USB drive. To locate the internal USB connector, see "System board
12.
components (on page 11)."
Install the FlexibleLOM (on page 21).
13.
Install the mezzanine assembly
14.
Install the access panel (on page 16).
15.
Install the server blade (on page 28).
16.
Power up the server blade (on page 14).
17.
To configure the memory mode, use UEFI System Utilities (on page 62).
("Remove the DIMM
baffles" on page 16).
("Install the DIMM
baffles" on page 17).
("Mezzanine card
("Remove the mezzanine
("Remove the direct connect SATA
("Install the direct connect SATA
option" on page 35).
Hardware options installation 49
cable" on
cable" on page

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis