Inhaltsverzeichnis
Werbung
Determine the status of the drive from the LEDs
4.
Storage controller/NVMe pass-through board
options
To install the component:
Back up all server blade data.
1.
Power down the server blade (on page 14).
2.
Remove the server blade (on page 15).
3.
Place the server blade on a flat, level work surface.
4.
Remove the access panel (on page 15).
5.
Prepare the storage controller/NVMe pass-through board for installation.
6.
Align the storage controller/NVMe pass-through board with the alignment pins and lower it into
7.
server blade.
("NVMe SSD
components" on page 10).
Hardware options installation 32
Werbung
Inhaltsverzeichnis
