Push the handle down into the closed position to fully seat the storage controller/NVMe pass-through
8.
board.
Install the access panel (on page 16).
9.
Install the server blade (on page 28).
10.
Power up the server blade (on page 14).
11.
Smart Storage Battery option
To install the component:
Power down the server blade (on page 14).
1.
Remove the server blade (on page 15).
2.
Place the server blade on a flat, level work surface.
3.
Remove the access panel (on page 15).
4.
If installed, remove the direct connect SATA cable
5.
page 19).
If installed, remove the internal USB drive. To locate the internal USB connector, see "System board
6.
components (on page 11)."
Remove the right DIMM baffle
7.
("Remove the direct connect SATA
("Remove the DIMM
baffles" on page 16).
cable" on
Hardware options installation 33