Remove the thermal interface protective cover from the heatsink.
14.
CAUTION: To avoid damage to the system board, processor socket, and screws, do not
overtighten the heatsink screws.
Using a T-15 screwdriver, install the heatsink.
15.
Install all DIMM baffles
16.
Do one of the following:
17.
o
Install the storage controller/NVMe pass-through board.
o
Install the direct connect SATA cable (on page 19).
Install the access panel (on page 16).
18.
Install the server blade (on page 28).
19.
Power up the server blade (on page 14).
20.
Memory options
("Install the DIMM
baffles" on page 17).
Hardware options installation 42