Inhaltsverzeichnis
Werbung
Remove a drive
Back up all server blade data on the drive.
1.
Remove the drive.
2.
Install the front panel/drive cage assembly
Power down the server blade (on page 14).
1.
Remove the server blade (on page 15).
2.
Place the server blade on a flat, level work surface.
3.
Remove the access panel (on page 15).
4.
Do one of the following:
5.
o
Remove the storage controller/NVMe pass-through board (on page 22).
o
Remove the direct connect SATA cable (on page 19).
Install the front panel/drive cage assembly.
6.
Align the pins on the chassis and slide the front panel/drive cage assembly into the server.
a.
Secure the component with two T-15 screws.
b.
Close the serial label pull tab.
c.
Install all DIMM baffles
7.
Do one of the following:
8.
o
Install the storage controller/NVMe pass-through board.
("Install the DIMM
baffles" on page 17).
Operations 23
Werbung
Inhaltsverzeichnis
