Technical Data; Noise/Vibration Information - Reich 3718 Technische Daten

4 I English
1

TECHnICAL DATA

Type
Dimensions mm
Weight kg (without fasteners)
single sequential or contact actuation
Recommended operating pressure
range
Maximun permissible operating
pressure
Air consumption per driving
operation
Magazine capacity
(no. of nails/staples)
Penetration depth setting
Fasteners:
T nails
nail length mm
Wire thickness mm
Staples Q
staple length mm
Wire thickness mm
staple width mm
Recommended lubricant
1 litre special oil. Code no.
250 cm3 grasa especial. Code no.
2

nOIsE/VIbRATIOn InFORMATIOn

Noise characteristic values *
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
A-weighted sound power level
L WA, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a)
The noise level when working can exceed 85
db (A). Wear ear protection!
* Measured values determined according to
En 12549:1999.
** Measured values determined according to
IsO 8662-11:1999.
3 suPPLIED WITH
1 Combination nailer
1 Instructions handbook
1 Technical data sheet
Karl M. Reich Verbindungstechnik GmbH
4
3718
Only those fasteners specified under technical data
(see 1) may be used.
320/370
When filling the magazine, hold the tool so that the
3.0 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
5 - 8.5 bar /
yoke or trigger depressed.
0.5 - 0.85 MPa
Place the tool on its side. Pull the magazine pusher
8.5 bar / 0.85
(l) to the back. Insert fasteners (nails or staples) into
MPa
the magazine (m) and lock the magazine pusher back
0.5 l at
into place.
7 bar / 0.7 MPa
Nails and staples may not be in the magazine at the
same time.
100/150
yes
5
The penetration depth is adjusted using air pressure.
should this not suffice, a more exact setting of the
32 - 65
penetration depth can be achieved by turning the
2.2
setting nut (p).
Right-hand turn (u) = less penetration depth.
Left-hand turn (D) = more penetration depth.
32 - 65
1.6 x 1.9
6
11.2
-sInGLE TRIGGER RELEAsE/RELEAsE On COnTACT-
9 4420
A setting wheel on the trigger (s) can be turned to set
the type of actuation either to single trigger release
68 3868
or release on contact (see symbol).
7
3718
balancer for 30 - 55 n (3.0 - 5.5 kp),
cable travel 2.0 m (5.2 ft).
83.2 dB(A)
96.2 dB(A)
3.11 m/s2
fIllInG The MaGaZIne
FIL PEnETRATIOn DEPTH sETTInG
sWITCHAbLE ACTuATIOn
ACCEssORIEs
3718
Code No.
28 6478
REICH ®