After Installation - Klarstein Windwaker Eco Bedienungsanleitung

After Installation

Check whether the requirements listed in the table are met or whether there are any
malfunctions:
To check
Has the device been securely installed?
Would a refrigerant leak test be
performed?
Have the lines been sufficiently insulated? Condensation and dripping water could
Is the water drained correctly?
Does the mains voltage of the socket
correspond to the voltage indicated on
the appliance's nameplate?
Have the electrical cables and lines been
installed correctly?
Has the appliance been properly
earthed?
Does the power cord used meet the
manufacturer's requirements?
Are the air inlets and outlets blocked by
anything?
Have dust and dirt residues been
removed during installation?
Are the gas valve and liquid valve fully
open?
Have the inlet and outlet of the pipe
opening been covered?
Possible malfunction
The unit may fall, wobble or make a
noise during start-up.
Insufficient cooling (or heating) capacity
could result.
result.
Condensation and dripping water could
result.
Malfunctions may be caused or parts of
the unit may be damaged.
Malfunctions may be caused or parts of
the unit may be damaged.
This could result in electrical leakage.
Malfunctions could be caused or parts of
the device could be damaged.
Insufficient cooling (or heating) capacity
could result.
Malfunctions may be caused or parts of
the unit may be damaged.
Insufficient cooling (or heating) capacity
could result.
Insufficient cooling (or heating) capacity
or waste of energy could result.
EN
93