Klarstein Windwaker Eco Bedienungsanleitung Seite 64

EN
64
• Do not stand on the top cover of the unit or place heavy objects on it as this may
result in property damage and/or personal injury.
• Installation must be performed by qualified personnel. Failure to do so may result in
property damage and/or personal injury.
• Electrical safety regulations must be observed when installing the equipment.
• Ensure that power supply switches and circuit breakers are installed and used in
accordance with local safety regulations.
• Install a circuit breaker. Failure to install an isolating switch may result in malfunction
of the equipment.
• An all-pole circuit breaker should be installed in the fixed wiring with a distance of
at least 3 mm between the poles.
• The unit should be fully grounded. Insufficient grounding may result in electric shock.
• Use only the power cord recommended by the manufacturer.
• Ensure that the power supply meets the requirements of the equipment. Inadequate
power supply or incorrect wiring may cause the unit to malfunction. Install the
correct power lines and cables before using the product.
• Connect the live wire, neutral wire, and ground wire correctly.
• Make sure to unplug the appliance from the power supply before performing any
electrical work.
• Do not plug the power plug into the wall outlet until the installation is complete.
• If the power cord is damaged, it must be replaced by the manufacturer, customer
service or a similarly qualified person to avoid hazards.
• The temperature of the refrigerant circuit will be high. Keep the connecting cable
away from the copper lines.
• The unit must be installed in accordance with national wiring regulations.
• The air conditioner is a high quality electrical appliance. It must be grounded by
a qualified person using a special grounding device. Always make sure that the
grounding is done correctly, otherwise there is a risk of electric shock.
• The yellow-green cable of the air conditioner is the earthing cable which must not
be used for other purposes.
• The grounding resistance should comply with national electrical safety regulations.
• The unit must be installed so that the mains plug is easily accessible.
• All cables and lines of the equipment should be connected by a qualified person.