Klarstein Windwaker Eco Bedienungsanleitung Seite 74

EN
74
I FEEL - Room Temperature Detection
When you press this button, this function is started and
control screen. After activating this function, the remote control sends the measured
ambient temperature to the unit. The air conditioner will then adjust the temperature
accordingly. If you press this button again, the function is terminated and the symbol
disappears from the remote control screen.
• When using this function, place the remote control near you and be careful not to
place the remote control near objects with high or low temperatures as this may
cause incorrect ambient temperature values to be measured.
• When this function is active, the remote control should be near the air conditioner so
that it can receive the signal sent by the remote control.
TIMER - Setting the Timer
Set the power-on timer:
Press TIMER ON to set the air conditioning on time. When you press the button, the
clock icon on the screen disappears and the word [ON] blinks on the remote
control. Press the ARROW buttons to adjust the setting. Each press increases or
decreases the setting by one minute. Pressing and holding these buttons changes the set
time more quickly. Release the corresponding button once you have reached the desired
time setting. Press the Timer on button to confirm your setting. The word [ON] will stop
blinking and the timer icon will be displayed again.
Note: To cancel this function, press the TIMER ON button again.
Set Off Timer:
Press TIMER OFF to set the air conditioner off time. When you press the button, the clock
icon on the screen disappears and the word [OFF] blinks on the remote control.
Press the ARROW buttons to adjust the setting. Each press increases or decreases the
setting by one minute. Pressing and holding these buttons changes the set time more
quickly. Release the corresponding button once you have reached the desired time
setting. Press the TIMER ON button to confirm your setting. The word [OFF] will stop
blinking and the timer icon will be displayed again.
is displayed on the remote