Selecting Profi Les; Cooling - Leister VARIANT T1 Bedienungsanleitung

1. Work Mode
1.7 Selecting Profi les
• If the display
be loaded by pressing the e-Drive
profi le can be selected by turning the e-Drive
be defi ned by users themselves (see Section 2 Profi le Setup). All other profi les have
permanently assigned values and cannot be defi ned by the user (Fig. 14).
• Turning the e-Drive
bottom.
Right arrow
to the next page (Fig. 15).
Left arrow
to the previous page (Fig. 16).
• If the Back arrow
ning the e-Drive
to the menu from which the Profi les menu
has been selected by pressing the e-Drive
(Fig. 15).
Carry out a test weld according to the welding instruction of the material manufacturer and national
standards or guidelines. Check test weld.

1.8 Cooling

• If the symbol
«Cool down OK?» will appear (Fig. 18). Pressing the e-Drive
symbol OK at the right bottom of the display (5). This initiates the cooling process.
• During the cooling down process, the air volume is increased to 100% and
the instantaneous welding temperature displayed (Fig. 19).
If the welding temperature of 60°C is fallen below, the blower will continue to ope-
rate for 2 minutes and will automatically switch off after this time expires.
The display changes to the Setpoint Value display.
• If the e-Drive
ating will start and the Work Display will appear on the display
(5) (see Section 1.2 Work Display).
• If the Cool Down menu is active, the drive can be switched on/
off manually via the Drive
The Heating
tion.
at the right bottom of the display (5) is activated, profi les can
. The display «Select Profi le» then appears. A
activates left or right arrows on the display (5) at the
by pressing the e-Drive
by pressing the e-Drive
is activated by tur-
, you will be taken back
is selected by pressing the e-Drive
is pressed during the cooling process, the he-
button.
and Blower buttons do not have any func-
. The profi les FREE 1–7 and 3 can
(Fig. 15)
(Fig. 17), the menu
activates the
(Fig. 14)
(Fig. 16)
(Fig. 17)
(Fig. 18) (Fig. 19)
31