Braun Multiquick 7 K 3000 Handbuch Seite 11

This disc can be used from both sides (coarse/
fine). Soft foods (e.g., cucumbers) should be
processed at speed 1–7, hard foods can be
shredded at a speed up to 15.
Processing examples (coarse): cucumbers,
kohlrabi, beetroot, carrots, raw potatoes,
apples, cabbage.
Processing examples (fine): cheese (soft,
medium hard), cucumbers, carrots, raw
potatoes, apples.
â
Grating disc
Speed 7–15
The writing must be facing the user.
Processing examples: raw potatoes (e. g., for
potato pancakes), horseradish, parmigiano
cheese (hard).
C Liquidiser goblet
(see page 5)
t
Use the liquidiser goblet for mixing,
chopping and cutting small quantities.
r
Lid
s
Blade
t
Liquidiser goblet
Ö
Screw fastening
Ü
Plastic ring
á
Chopper/mixer bowl
à
Seal
â
Drive shaft with bottom
Maximum capacity: 1l liquid
(for milk-shakes 750 ml).
Larger quantities should preferably be proces-
sed in the food processor bowl
o
universal blade .
Important: The maximum processing time in
the liquidiser goblet is 1 minute. (Liquids may be
processed longer.)
s
Caution! The blade is very sharp – only take
hold of it by the plastic knob.
Place all ingredients into the liquidiser
goblet after having inserted the blade
(see processing table on page 13).
Liquids can only be added through the hole
in the lid if the motor is running. After use,
always remove the blade from the goblet
before removing the processed food.
Blending of soups, milk-shakes,
baby food etc.
Speed 1–15, approx. 1 min
Cut the fruits for milk-shakes into smaller
pieces and process it before adding liquid.
Maximum capacity: 750 ml liquid, otherwise
it could froth over.
Hot foods can also be blended in this heat-
resistant goblet. Baby food remains warmer
if the liquidiser goblet is warmed with hot water
beforehand.
Chopping
Speed 1–15, auto.pulse
Processing examples: Parsley, garlic, onions or
nuts can be chopped, as well as hard bread
rolls for bread-crumbing and meat.
Do not chop: chocolate, parmigiano cheese,
ice, hard spices or coffee.
12
Disassembling and assembling
the liquidiser
r
Lid
For cleaning, remove the seal from the inside
of the lid. Please replace the dry seal so that
the plastic clips in the lid fit into the groove of
the seal (H).
s
Blade
Caution! The blade is very sharp.
Remove the blade from the goblet by taking
hold of the knob and, while pressing down
with your thumb, pulling it off the drive shaft (I).
To insert the blade into the goblet, press it
onto the drive shaft until it clicks.
Liquidiser goblet
Remove the blade as described above.
To disassemble the goblet (J), first turn it
upside down, reach into it with one hand and
hold the plastic base of the drive shaft.
Then, using the pusher, unscrew the fastening
of the bottom by turning anti-clockwise.
Take off the screw fastening (a), the plastic
ring (b) and the goblet (c) one after the other,
so that finally, you only hold the drive shaft (e)
with bottom and seal (d) in your hand.
To re-assemble, please proceed in the
reverse order (K):
Place the seal onto the lower side of the drive
shaft bottom.
Turn the goblet upside down and place the
opening in the goblet bottom over the seal
on the drive shaft bottom. Please, be careful
not to dislocate the seal.
Place the plastic ring (b) onto the goblet
bottom so that the projection on the plastic
ring engages with the groove in the bottom
p
with the of the goblet (next to handle).
Fasten all of these parts by turning the screw
fastening (a) clockwise by means of the pusher.
Subject to change without notice.
Please do not dispose of the product in
the household waste at the end of its
useful life. Disposal can take place at
Braun Service Centre or at appropriate
collection points provided in your country.
t