GEZE Perlan KS series Montageanleitung Seite 107

Controller and external push buttons
The controller must be fitted indoors. The best mounting location is
in a control cabinet, with external operating push buttons located
in the rooms and connected to the controller. Use only push button
switches, not rotary, toggle or other switch types. The direction but-
tons should be interlocked and labelled "On/Off" or with left and right interlocked and labelled "On/Off" or with left and right interlocked and labelled "On/Off" or with left and right
arrows. Although not essential, these features are recommended for
convenience.
Laying the cables
The motor can be mounted either on the left or the right side at the
top of the shutter system. The exact position should be established
before the cables are laid. The motor must not be exposed to rain or
other precipitation.
Cable specifications
Controller -> motor
Push button -> controller
Bus control
The controller can be connected to an existing control bus. In this
case, connect a floating actuator to terminals 6, 5 and 3.
Group control
Floating terminals 6, 5 and 3 can be joined to implement a group
control.
Installing in a flush-type box
The push button–transformer unit can be mounted in a flush-type
box. The transformer is housed fully inside the box in that case.
Frame
The plastic frame is compatible with the range of switches, for
example series CD500 of Jung GmbH.
Technical specifications
Mains connection: 230 V 50 Hz ±10 %
Output voltage/current for motor: 24 V DC / 2 A
Output voltage/current for auxiliary devices: 24 V DC / 80 mA
Temperature range for motor: -20 °C to +60 °C
Temperature range for controller: -10°C to +60 °C
Up to 10 m: 2 × 1 mm²
Up to 20 m: 2 × 1.5 mm²
Cable type: H05, ... H07, ... NYM or
similar rated at least 24 V DC / 2 A
Up to 20 m, 3 × 0.5 mm²
Screened cable
47
GB