Waeco PerfectView LCD250 Montage- Und Bedienungsanleitung Seite 44

_RV-250.book Seite 44 Donnerstag, 14. Dezember 2006 4:54 16
PerfectView LCD250
8.3 Switching the monitor to day mode or night mode
When in night mode, the monitor darkens the image on the monitor to prevent glaring light
that can distract the driver.
➤
Press the main switch "MODE" (0 3, page 6).
✓
The monitor is switched from day mode to night mode or vice versa.
✓
This LED "COLOR" (0 9, page 6) is lit orange if the monitor is operating in
day mode.
✓ This LED "COLOR" (0 9, page 6) is lit green if the monitor is operating in
night mode.
8.4 Setting the volume
You can set the volume to amplify or mute the the noises transmitted by the camera.
➤ Press the "–" button (0 5, page 6) to reduce the volume.
➤
Press the "+" button (0 6, page 6) to increase the volume.
8.5 Setting the monitor
To set the monitor to suit your requirements, proceed as follows:
➤
Press the "MENU" button (0 4, page 6) once to set the desired brightness.
✓ The LED "C1" (0 7, page 6) starts flashing.
➤
Press the "–" button (0 5, page 6) to reduce the brightness.
➤
Press the "+" button (0 6, page 6) to increase the brightness.
➤
Press the "MODE" button (0 3, page 6) to exit setup mode.
➤
Press the "MENU" button (0 4, page 6) twice to set the desired contrast.
✓
The LED "C2" (0 8, page 6) starts flashing.
➤
Press the "–" button (0 5, page 6) to reduce the contrast.
➤
Press the "+" button (0 6, page 6) to increase the contrast.
➤
Press the button "MODE" button (0 3, page 6) to exit setup mode.
➤
Press the "MENU" button (0 4, page 6) three times to set the desired tint.
✓
The "COLOR" LED (0 9, page 6) starts flashing.
➤
Press the "–" button (0 5, page 6) to reduce the tint.
➤
Press the "+" button (0 6, page 6) to increase the tint.
➤ Press the button "MODE" button (0 3, page 6) to exit setup mode.
You can reset the monitor to the factory settings for brightness, contrast, tint
and volume.
To do this, proceed as follows:
➤ Press the "MENU" button (0 4, page 6) once.
✓
The LED "C1" (0 7, page 6) starts flashing.
➤
Press the "C1/C2" button (0 2, page 6).
Using the LCD-monitor
44