Program Smart Probe - WIKA CTR3000 Betriebsanleitung

6. Commissioning, operation

6.4.8.2 Program SMART probe

By pressing the button [Program SMART probe] in the application [Service], the SMART probes can be programmed under
the customer-specific service level. The menu opens on the right side.
Here all settings can be done which are stored on the EEPROM on this SMART probe. Similar to the settings for new probes.
Please refer to chapter 6.4.3.1 "New probe [Resistance thermometers]" to understand the meaning of these settings.
No history is stored on the memory!
This can only be done while a SMART probe is connected and on the main screen, the channel is selected where
the SMART probe is connected. Otherwise an error log is raised.
WIKA operating instructions, model CTR3000
EN
57