Smart Probes; Application [Scan] - WIKA CTR3000 Betriebsanleitung

6. Commissioning, operation

6.4.3.5 SMART probes

Under the menu chapter "SMART probes" you can disable SMART probes. When a SMART probe is disabled for a channel,
the instrument uses the probe settings assigned to the channel.
EN
By clicking on the button [List connected smart probes] all connected SMART probes will be listed on the right side with
their probe name. Every probe highlighted in orange is enabled/active and all others not. Press on the button of an active
SMART probe means that this will be disabled. This setting has to be confirmed with [Yes] or [No].
When SMART probe disabled for a channel, the instrument uses the probe settings assigned to the channel.
The scan of listed smart probes cannot be done while a scan is active.

6.4.4 Application [Scan]

The application [Scan] describes the function of this instrument that sequentially measures each channel and either
temporarily shows the data on the display in the selected view. Scans are started manually by the user. To scan a channel, the
CTR3000 sequentially cycles through the channels that are selected and makes measurements. Therefore this function allows
the user to see more channels on the screen and to have a more or less automatic measurement of several channels.
Modules are only available and selectable if these are connected.
42 WIKA operating instructions, model CTR3000