Initial Start-Up - Siemens BOP-2 Commissioning

Initial startup
Once the BOP-2 is fitted and powered-up it will automatically detect the type of Control Unit to which
it has been fitted and attempt to automatically establish communications.
Once communications have been established, an internal check is
performed to ensure that the Operator Panel is responding correctly.
Once all checks have been completed the BOP-2 will display the
standard status screen. The BOP-2 is now ready for use.
If after establishing communications there is a pending fault or alarm,
the BOP-2 will display the relevant fault or alarm number.
If there is more than one fault or alarm, use the
move through the list on the screen.
CAUTION
Action on fault during parameter editing
If a fault occurs during parameter editing, the fault screen must be exited by pressing
order to allow the editing cycle to be completed.
On a Safety Parameter Reset the Inverter MUST be power-cycled after the fault screen has been
exited.
BOP-2, Getting Started Guide 03/10 A5E02826349A
and keys to
MONITORING MONITORING CONTROL CONTROL DIAGNOSTICS DIAGNOSTICS
CU RESP
PARAMETER PARAMETER SETUP SETUP
MONITORING MONITORING CONTROL CONTROL DIAGNOSTICS DIAGNOSTICS
SP 1500. 0
1500. 0
PARAMETER PARAMETER SETUP SETUP
MONITORING MONITORING CONTROL CONTROL DIAGNOSTICS DIAGNOSTICS
FAULTS
0. A8752
PARAMETER PARAMETER SETUP SETUP
or
EXTRAS EXTRAS
EXTRAS EXTRAS
EXTRAS EXTRAS
in
7