Siemens BOP-2 Commissioning Seite 6
Basic operator panel
Vorschau ausblenden
Andere Handbücher für BOP-2:
- Betriebsanleitung (50 Seiten) ,
- Betriebsanleitung (58 Seiten)
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fitting the BOP-2 to the Control Unit
To fit the BOP-2 to the Inverter Control Unit the following procedure should be performed:
1.
Place the bottom edge of the BOP-2 casing into the lower recess of the Control Unit
housing.
2.
Push the BOP-2 towards the Control Unit until the release-catch clicks into place on the
Control unit housing.
To remove the BOP-2 from the Control Unit, press down on the release-catch and pull the BOP-2 off
the Control Unit.
6
BOP-2, Getting Started Guide 03/10 A5E02826349A
Werbung
