Herunterladen Inhalt Inhalt Diese Seite drucken

Topping Up The Oil; Connecting To A Compressed Air Source - Parkside PDBNP 14 A1 Originalbetriebsanleitung

Druckluft-blindnietpistole
Vorschau ausblenden Andere Handbücher für PDBNP 14 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4

Topping up the oil

To ensure that the rivet gun remains operational for as long as possi-
ble, make sure that there is sufficient pneumatic oil in the appliance.
The following options are available:
Attach a maintenance unit with an oiler to the compressor.
Install a fitted oiler into the compressed air line or the compressor.
Manually add 3–5 drops of pneumatic oil from the supplied oil
container
operation.
When opening the oil container
cap nut from the container. Use a pair of long-nosed pliers or
similar implement to remove the internal pipette.
Turn it 180 °, replace it and screw it back in place with the cap nut.
Use a needle or similar tool to poke a small hole into the tip of the
pipette to release oil.

Connecting to a compressed air source

NOTE
Before connecting the compressed air source,
the correct working pressure (3–6 bar) must be fully
reached
ensure that the trigger
Remove the cover
To seal the thread on the connecting nipple
of the sealing tape
screw the connecting nipple
GB │ IE
36 
into the connecting nipple
from the compressed air supply
around it. Use the assembly spanner
every 15 minutes of
for the first time, remove the
is not pulled
, wrap 2 or 3 layers
into the compressed air supply
.
to
PDBNP 14 A1
.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis