Data Menu - Counter Display And Zeroing; How To Access The Programming Mode - La Cimbali M39 Dosatron TE Gebrauch Und Installation

Counters are displayed by pressing the
The following message appears on the display (5):
COUNTERS MENU
N° coffee gr. 1
N° coffee gr. 2
N° coffee gr. 3
N° water
N° steam
Parameters calculated are:
- N. coffee (number of coffee beverages)
- N. water (number of times water is dispensed)
- N. steam (number of times steam is dispensed using
the steam button)
- N. steam TS (number of times steam is dispensed using
the turbosteam function)
- N. steam + air TS (number of times steam and air are
dispensed using the turbosteam function)
- N. tot coffee (total number of coffee beverages).
N.B. ONLY if the item "Customer Progr." is set on
"YES" and the item "Program. block" is set on
"NO".
To access programming press the
following message will appear on the display:
CUSTOMER PROG.
KEY MENU
Press one of the dispensing keys on the selection panel
(2); the relative led will remain on.
Use the "+" (30) and
cursor (black line) on the desired line, then press the
"PRG" key (29).
Always use the "+" (30) and
the setting; at this point there are two possibilities:
2) exit the menu and leave the settings unchanged by
pressing the "RES" key (24).

19. DATA menu - Counter display and zeroing

(27) key.
+
01234
01234
01234
01234
01234

20. How to access the programming mode

"PRG" key (29); the
"-" (31) keys to position the
"-" (31) keys to change
key
Counters can be zeroed by aligning the cursor on the
selected entry, pressing the
pressing the "+" (30) or
Press the "RES" key (24
The "N. coffee" entry appears for as many times as there
are machine groups.
Note: Parameters that cannot be zeroed are:
- N. tot coffee
Press the "RES" key (24) to return to the main menu.
Note: When modifying data, the cursor changes to "
", or a slide bar with maximum and minimum
settings will appear:
MM1 cof. dose
-5
-
If the "Customer Progr." is set to "NO", the following
message will appear on the display:
CUSTOMER PROG.
NOT ENABLED!
18 EN
"PRG" key (29), and then
"-" (31) key.
064
064 +5
+