Cleaning And Maintenance - Sunred FT17G Anleitung

·If the pilot flame dose not light or it goes out,
Shut off the control knob. A 5-minute complete shutoff period is necessary before relighting.
Please confirm the control knob on the off position before to light the heater.
·If a new tank has just been connected, please allows at least one minute for the air in the air in the gas pipeline to
purge out through the pilot hole.
·When lighting the pilot flame make sure that the variable control knob is continuously pressed down while pressing
the lighter button. Variable control knob can be released after the pilot flame lights.
·Pilot flame can be watched and checked from the square window with sliding lid(Figure 1&2) located at the bottom
of the flame screen The pilot also can be lighted by match.
Take off the sliding lid, through the window to light the pilot by match.
TO TURN OFF THE HEATER
1. Press and turn the variable control knob to OFF position.
2. Turn off the valve on the gas supply cylinder completely.
Figure1

CLEANING AND MAINTENANCE:

Figure2
- 8 -