Cleaning And Care - Sunred SFT15 Serie Handbuch

PLEASE READ CAREFULLY THE FOLLOWING SAFETY GUIDELINES BEFORE OPERATION
TO TURN ON THE HEATER
1. Depress and turn control knob clockwise to OFF position.
2. Fully open gas valve.
3. Depress control knob and turn knob counter-clockwise to IGNITE position, then to PILOT position (you will hear 2 clicks).
4. With the pilot light lit, keep control knob depressed for 30 seconds.
NOTE
If the pilot light has not ignited, turn heater control knob to OFF position, fully close gas valve, wait 5 minutes, then repeat steps 2–4 of
the Lighting Instructions.
NOTE
If the pilot light ignites but does not stay lit, turn heater control knob to OFF position, fully close propane gas valve, wait 5 minutes, then
repeat steps 2–3. Now, using a lighter, ignite the pilot light through the ignition hole on the emitter screen. Once the pilot light is lit, de-
press control knob for 30 seconds.
5. After depressing the control knob for 30 seconds, turn control knob to LOW. To increase the temperature, turn towards HIGH.
WARNING
Check that no broken on the glass is found before operation.
TO TURN OFF THE HEATER
1. Fully close gas valve.
2. Turn control knob clockwise to OFF position.
STORAGE
1. Always close the gas value of the gas cylinder after use or in
case of a disturbance.
2. Remove the pressure regulator and the hose.
3. Check the tightness of the gas valve and if you suspect a damage,
have it changed by your gas dealer.
4. Never store liquid gas cylinder in a sub-terrain, or at places
without adequate air ventilation.

CLEANING AND CARE

•
Wipe off powder coated surfaces with soft, moist rag. Do not clean heat-
er with cleaners that are combustible or corrosive.
•
Remove debris from the burner to keep it clean and safe for use.
•
Cover the burner unit with the optional protective cover when the heat-
er is not in use.
CAUTION
Off: The heater stop working
Hi: Maximum temperature position
Lo: Minimum temperature position
Vertaling variable control knob
Vertaling igniter
EN
7