Leakage Test - Sunred FT17G Anleitung


Use propane, butane, propane and butane mixture.

Maximum inlet pressure of regulator must to exceed 100 PSI.

The pressure regulator and hose assembly to be used must conform to local standard codes.

Use correct pressure regulators conform to local regulation in force and specification in page 7 of this manual.

The installation must conform to local codes, or in the absence of codes, with the standard for storage and
handling of liquid petroleum gases.

A dented, rested or damaged propane tank may be hazardous and should be checked by your tank supplier.

Never use a propane tank with a damaged valve connection.

The propane tank must be arranged to provide for vapor withdrawal from the operation cylinder.

Never connect an unregulated propane tank to the heater.

The rubber hose which connect the regulator and inlet should not longer than 60 cm

The rubber hose should be got CE approval, and heat resistant should be between-20℃ to 80℃
Gas connections on the heater are leak tested at the factory prior to shipment. A complete gas tightness check must
be performed at the installation site due to possible mishandling in shipment or excessive pressure being applied to
the heater.
•
The heater must be checked with a full cylinder.
•
Make sure the safety control valve is in the OFF position.
•
Make a soap solution of one part liquid detergent and one part water. The soap solution can be applied
with a spray bottle, brush or rag.
•
Soap bubbles will appear in case of a leak.
•
Leakage test points. See pictures below.
•
Turn the gas supply ON.
•
In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the gas supply on and
recheck. Contact your dealer for assistance if bubbles continue to appear.
•
Never leak test while smoking.
LP gas and natural gas have manmade odorants added specifically for detection of fuel gas leaks. If a gas leak occurs

LEAKAGE TEST

FUEL GAS ODOR
- 6 -