Cleaning The Oven Door - hanseatic 10153.3eETsDpHbX Gebrauchsanleitung

Page EN-16 Cleaning

Cleaning the oven door

NOTICE
Risk of breakage and injury!
The oven door is equipped with heavy
glass panels that can break if handled
improperly. The glass shards are sharp
and can cause injury.
Do not let the oven door or individual
■
glass panels fall.
Do not hit the oven door and the indi-
■
vidual panels of glass anywhere.
Removing the oven door from its hinges
The oven door can be removed from its
hinges to enable easy cleaning of all areas
of the oven:
1. Open the oven door completely.
(11)
2. Fold the clips (11) on both sides all the
way forward. Use a screwdriver if neces-
sary.
3. Close the door only so far that it is still
open about 10 cm.
4. Lightly lift and guide the door forward out
of its hinges.
Replacing the oven door on its hinges
1. Hold the oven door at an angle using both
hands.
2. Hook the hinges into the holes in the side
panels.
3. Open the oven door completely.
4. Fold the clips (11) on both sides all the
way back again.
5. Close the door carefully. The door must
sit flush when closed. If the door does not
sit flush when closed or if there is a crack-
ing sound when closing it, the door is not
hung properly.
6. Correct the position of the hinges and
clips, if necessary, until the door opens
and closes smoothly again.
Cleaning the glass panes
The oven door contains three glass panels
that should occasionally be cleaned on both
sides. To do this you'll need a PH1 Phillips
screwdriver.
1. Take the oven door off its hinges (see
„Removing the oven door from its hinges"
on page EN-16).
2. Carefully removed the metal grid.