Sharpening The Wedge; Sharpening The Splitter; Changing The Hydraulic Oil; Ordering Spare Parts - EINHELL BT-LS 1014 D Bedienungsanleitung

Anleitung_BT_LS_1014_SPK7:_
GB

9. Sharpening the wedge

1. Once it has been in use for some time, or as and
when necessary, you should sharpen the wedge
with a fine-toothed file and carefully remove any
burrs or flat areas on the edge.
Important!
Always disconnect the device from the power supply
before starting any maintenance work!

10. Changing the hydraulic oil

Important! Hydraulic oil gets very hot during
operation. Always allow the machine to cool
down for a while before you start to change the
oil.
1. Make sure that the splitter is fully retracted.
2. Remove the oil filler screw (Fig. 12/item 22).
3. Undo the oil drain screw (Fig. 18/item 23) and
place a vessel with a capacity of at least 6 liters
under the oil drain screw.
4. Remove the oil drain screw fully by hand so that
the oil drains into the vessel.
5. When all the oil has drained, clean the oil drain
screw and screw it back into position.
6. Place a funnel in the opening in the oil filler
screw and pour in 2.5 – 4 liters of hydraulic oil.
7. Clean the oil dipstick at the oil filler screw and
check the oil level by inserting the dipstick into
the opening in the oil filler screw. The oil level
must be between the two marks on the oil
dipstick (Fig. 13).
Recommended hydraulic oil
We recommend that you use one of the following
makes of hydraulic oil for the hydraulic cylinder:
SHELL TELLUS T22
ARAL VITAM GF22
SP ENGERGOL HCP22
MOBIL DTE11
or an alternative of the same quality
16
10.07.2007 16:37 Uhr Seite 16

11. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info