Transport And Storage; Sharpening The Wedge; Changing The Hydraulic Oil - EINHELL 34.320.60 Originalbetriebsanleitung

Anleitung_BT_LS_810_D_SPK7:_
of the power cable becoming damaged.
9. Do not forget to retighten oil filler screw (Fig.
16/Item 14) when you have finished your wood
splitting work.
Releasing a jammed trunk
1. Retract the splitter fully.
2. Position a wedge-shaped piece of wood on the
trunk support.
3. Move the splitter downwards. The jammed trunk
will be pushed forward by the wedge-shaped
piece of wood.
4. Repeat this process with larger and larger
wedges until the jammed is released.
Important!
Never hammer against the stuck trunk or place
your hands anywhere near the trunk when trying
to release it.
NEVER ASK ANYONE ELSE TO HELP WHEN
TRYING TO RELEASE A TRUNK WHICH HAS
BECOME STUCK.
NEVER ATTEMPT TO RELEASE THE TRUNK
BY HITTING IT WITH A TOOL.

8. Transport and storage

Transport
1. Move the splitter as far downwards as possible
2. Switch off the wood splitter and disconnect the
mains lead
3. Fold the hand guards together and secure with
the supplied expander (Fig. 2/Item 21).
4. Transport the wood splitter using the transport
handle in the required position (Fig. 11)
Important. The wood splitter may only be
transported in an upright position. If it is transported
in a horizontal position, the hydraulic oil must be
drained (see section 10)
Storage
Only store the wood splitter in dry rooms and in
an upright position
Move the splitter as far downwards as possible
for storage
17.06.2010 13:36 Uhr Seite 17

9. Sharpening the wedge

1. Once it has been in use for some time, or as and
when necessary, you should sharpen the wedge
with a fine-toothed file and carefully remove any
burrs or flat areas on the edge.
Important!
Always disconnect the device from the power supply
before starting any maintenance work!
10. Changing the hydraulic oil (Fig. 15-
17)
Important! Hydraulic oil gets very hot during
operation. Always allow the machine to cool
down for a while before you start to change the
oil.
1. Make sure that the splitter is fully retracted.
2. Remove the oil filler screw (Fig. 16/Item 14).
3. Undo the oil drain screw (Fig. 15/Item 19) and
place a vessel with a capacity of at least 8 liters
under the oil drain screw.
4. Remove the oil drain screw fully by hand so that
the oil drains into the vessel.
5. When all the oil has drained, clean the oil drain
screw and screw it back into position.
6. Place a funnel in the opening in the oil filler
screw and pour in 5 liters of hydraulic oil.
7. Clean the oil dipstick at the oil filler screw and
check the oil level by inserting the dipstick into
the opening in the oil filler screw. The oil level
must be between the two marks on the oil
dipstick (Fig. 17).
Important. Dispose of the old oil in accordance with
current regulations
Recommended hydraulic oil
We recommend that you use one of the following
makes of hydraulic oil for the hydraulic cylinder:
SHELL TELLUS T22
ARAL VITAM GF22
SP ENGERGOL HCP22
MOBIL DTE11
or an alternative of the same quality
GB
17