Tylo SENSE SPORT Installationsanleitung Seite 7

Connect the electrical cable (1) to terminal (2) (see Figure 12,
Page 5) according to the wiring diagram (see The section
called Connection/wiring diagram, Page 7).
4
Figure 12: Circuit board
1. Electrical cable
2. Terminal for connection of electrical cable
3. Light cable (if relevant)
4. Terminal for connection of light (if relevant)
12. Connect light cable (if relevant) (3) see Figure 12, Page 5
to terminal (4) according to the wiring diagramFigure 18,
Page 7.
13. Close the cover and tighten the screws (see Figure 5, Page
3).
14. Use the drill template to mark where the heater is to be posi-
tioned (see Figure 13, Page 5). (This step is not required
if the heater is to stand on the floor. See separate instructions
for heater feet (option).)
Figure 13: Drill template
1. 298 mm
2. 308 mm
3. 290 mm
4. 48 mm
3 1
2
1
2
4
3
15. Attach the four brackets to the wall according to the tem-
plate marks. Mount the two lower brackets with their screw
holes downwards, so that they are hidden. Only the two upper
brackets need locking with lock screws (see Figure 14, Page
5).
Figure 14: Bracket and screws
16. Install the herb bowl/air humidifier (see Figure 15, Page
5).
Figure 15: Installing the fragrance holder/air humidifier
5