Tylo SENSE SPORT Installationsanleitung Seite 6

4
5. Slacken the bracket screws see Figure 7, Page 4.
Figure 7: Bracket screw
6. Lower the bracket and detach from the side. Turn bracket 180
° see Figure 8, Page 4.
Figure 8: Slacken and turn bracket
7. The cover can be detached by carefully bending it at the hinge
see Figure 9, Page 4.
Figure 9: Remove/secure cover
8. Insert the lock tongue into the designated hole. Secure the
bracket with the screw see Figure 10, Page 4.
Figure 10: Secure bracket
9. Replace the cover if removed earlier see Figure 9, Page
4.
10. Attach timer and thermostat dials. Insert the plugs on the op-
posite side see Figure 11, Page 4.
Figure 11: Secure dial and plugs
11.
WARNING! Always check that the heater is con-
!
nected to the correct main/phase voltage.
The heater is connected using standard wiring (Fk or EKK),
approved for fixed installation.
Any single wires (Fk) must be protected in electrical conduits
(VP) to the heater.