Installation; Sauna Heater Installation - Tylo SENSE SPORT Installationsanleitung

1
3
Figure 4: Positioning the inlet and outlet vents
1. Inlet vent position.
2. Outlet vent position through the sauna wall.
3. Outlet vent position through the cavity.
4. Outlet vent position via duct.
Positioning the outlet vent
DANGER! The outlet vent must not lead outdoors.
!
This may affect the heater temperature cut-out as
the ventilation direction could be reversed.
DANGER! Any gap above the sauna ceiling should
!
not be sealed without leaving at least one vent hole
on the same wall as the sauna door!
Position the outlet vent:
• with maximum distance to the inlet vent, e.g. diagonally (see
Figure 4, Page 3).
• high on the wall or in the ceiling (see Figure 4, Page 3).
• so that it vents into the space the door and inlet vent open in-
to.
The outlet vent must have the same area as the inlet vent.
Ensure that the outlet vent is open.
Mechanical ventilation is not recommended, because of the risk
of poor air exchange, which can have a negative effect on the
heater temperature cut-out.

INSTALLATION

2

Sauna heater installation

Preparing for installation is easiest when the heater is lying down.
To install the heater:
1. Lay the heater down front upwards.
2. Slacken the screws and open the cover (see Figure 5, Page
3).
4
Figure 5: Opening/closing the cover
3. Are the timer and thermostat dials on the side you want? If
yes, go to step 11. If no, go to step 4.
4. Detach timer and thermostat dials. Remove the plugs on the
opposite side of the heater see Figure 6, Page 3. To
avoid scratching the frame, remove the inner plugs first and
then the outer using a screwdriver as shown in the diagram.
Figure 6: Remove the dial and plugs
3