Before Installation; Parts; Installation Requirements; Installation Tools - Tylo SENSE SPORT Installationsanleitung

BEFORE INSTALLATION

Parts

Check that the following parts are included in the packaging:
2
3
1
Figure 1: Sauna heater parts
1. Sauna heater
2. Herb bowl/air humidifier
3. Brackets x 4
4. Warning sticker in ten languages
5. 3 mm Allen key
6. Lock screws x 2
7. Bracket screws x 8
8.
Connectors x 3
Contact your dealer if anything is missing.

Installation requirements

For detailed instructions concerning sauna construction/ventila-
tion etc., go to: http://www.tylö.se/byggabastu and download this
document: "Building a sauna.pdf".
To ensure safe use of the heater, check that the following criteria
are met:
• The sauna cabin shall meet the requirements for ceiling height
and dimensions according to: "Building a sauna.pdf".
• The sauna cabin shall meet the requirements for insulation
and materials according to: "Building a sauna.pdf".
• Cable (EKK) or electrical ducting for connecting the heater
must be run on the outside of the heat insulation.
• Cable installation must be correctly performed (see The sec-
tion called Connection/wiring diagram, Page 7).
• Fuse size (A) and power cable size (mm²) must be suitable
for the heater (see The section called Connection/wiring dia-
gram, Page 7).
• Sauna ventilation must comply with the instructions in this
manual (see The section called Positioning the inlet vent,
Page 2, The section called Positioning the outlet vent,
Page 3 and ).
• The position of the sauna heater, control panel and sensors
must comply with the instructions in this manual.
6
4
7
5
8
• Heater output (kW) must be suitable for the sauna volume
(m³) (see Table 1, Page 1). Minimum and maximum
volumes must not be exceeded.
NOTE! A brick wall without heat insulation increases
the warm-up time. Each square metre of plastered
ceiling or wall surface is equal to an additional 1.2–2
m³ of sauna volume.
Table 1: Output and sauna volume
Output kW
6.6
8
DANGER! Incorrect ventilation or heater positioning
!
can lead to the wooden panels drying out, causing a
risk of fire under certain circumstances!
DANGER! Insufficient insulation of the sauna cabin
!
can mean a risk of fire!
DANGER! Use of the wrong materials in the cab-
!
in, such as chipboard, plasterboard etc. can mean a
risk of fire!
DANGER! Connection of the heater must be per-
!
formed by a qualified electrician according to the
applicable regulations!

Installation tools

The following tools and materials will be required for installation
and connection:
• spirit level,
• adjustable spanner,
• electric drill,
• screwdriver.

Planning installation

Before starting to install your sauna heater:
• Plan where you will position it (see The section called Posi-
tioning the heater - normal installation, Page 2).
• Position the inlet vent (see The section called Positioning the
inlet vent, Page 2).
• Position the outlet vent (see The section called Positioning
the outlet vent, Page 3).
• Plan electrical installation see The section called Connec-
tion/wiring diagram, Page 7.
Sauna volume min./max. m³
4-8
6-12
1