Saving Data On The Memory Card - Lenze EPM-H410 Betriebsanleitung

6 Operation

Saving data on the memory card

6.6 Saving data on the memory card
You can save and archive your custom−designed configured project on this
ƒ
memory chip.
You can mount the memory chip with the saved project in an operating
ƒ
unit of the same type in order to transfer the project to this operating
unit.
The following operation is only provided to you if the memory module is
ƒ
mounted in the operating unit. (¶ 75)
You want to ...
A access the memory card.
Tansfer page is shown.
l
Select the Flash Card" menu.
l
B
Select the function.
l BACKUP
– Save project from the operating
unit on the memory chip.
RESTORE
l
– Transfer contents of the memory
chip to the operating unit.
l ERASE
– Delete contents of the memory
chip.
l EXIT
– Back to the transfer page.
C Exit the transfer page
94
Press keys ...
+
shift
Enter
F2
F1
F2
F3
F4
Enter
l
Example
H410 TRANSFER PAGE
Graphic controller BOOT check: OK
Graphic controller RAM check : OK
F1:MSP F2:FlashCARD ENTER:EXIT
FlashCARD MENU
Back-Up for: H410
Firmware present
Project present
F1:BACKUP F2:RESTORE
F3:ERASE F4:EXIT
H410 TRANSFER PAGE
F1:MSP F2:FlashCARD ENTER:EXIT
EDBPM−H410 DE/EN/FR 4.1