Disconnecting From The Pc - Lenze EPM-H410 Betriebsanleitung

F1 F2
F12 F13
F23 F24
Alarm Info
Ack All
Help
Ack
0
How to transfer a project to the operating unit:
1. Switch on the PC and start the »HMI Designer« planning tool.
2. Switch on supply voltage for operating unit.
3. When the message ENTER to download" appears on the display, press the
enter key 1 of the operating unit.
On the display the following selection is shown:
–
F1: MSP
–
F2: Memory CARD (only if the card is mounted)
–
ENTER: EXIT
4. Press F1 key
5. If the message Waiting for download from MSP" appears on the display,
load the desired project from the »HMI Designer« into the operating unit.
–
See "HMI Designer − Getting started" Manual.
–
PROGRAMMING MODE" is displayed during the download.
When the download is completed, the operating unit is ready for operation and
can exchange data with the connected nodes via the system bus (CAN).
5.2.3

Disconnecting from the PC

How to disconnect from the PC:
1. Switch off PC.
2. Switch off supply voltage for operating unit.
3. Remove EPZ−H110 download cable from the operating unit and the PC.
4. Switch on supply voltage for operating unit.
The operating unit is now ready for operation.
EDBPM−H410 DE/EN/FR 4.1
Project transfer to the operating unit
Bus Error Power Battery
F3 F4 F5 F6 F7 F8 F9 F10 F11
F14 F15 F16 F17 F18 F19 F20 F21 F22
· ±
V W X Y Z - PgUp
+ / =
Clr
Spare
7 8 9
Space
Esc
M N O P Q R S T U
shift
4 5 6
A B C D E F G H I J K L PgDN
Enter
0 1 1 2
1
H410_007
0
to activate download via the MSP interface.
l
Commissioning
Disconnecting from the PC
5
h410_007
81