5
Commissioning
Before switching on
5
Commissioning
Before switching on
Note!
If your configuration differs from the Lenze settings, please read the
ƒ
instructions given under "Individual settings".
Please observe
ƒ
– that the jumpers can only be plugged when the device is switched off.
– that the jumpers at the function module are set correctly.
– that C0034 matches the jumper setting
Example: Bipolar setpoint selection (-10 ... +10 V) via X3.1/1U
36
C0034/1 = 1, jumper in position "7 - 9"
37
39
37
EDK82ZAFAC-010 DE/EN/FR 4.0