Included Items; Technical Data - Parkside PSSAP 20-Li A1 Bedienungs- Und Sicherheitshinweise

Battery level button
10
Release button
11
Battery level indication light
12
Base plate adjustment button
13
Faster charger
14
Charge status LED - red
15
Charge status LED - green
16
Saw blade (not include)
17

Included items

1 cordless reciprocating saw PSSAP 20-Li A1
1 charger PSSAP 20-Li A1-2
1 battery pack PSSAP 20-Li A1-1
1 carry case
1 set of operating instruction

Technical Data

Cordless reciprocating saw:
PSSAP 20-Li A1
Rated voltage:
Rated idle speed:
Stroke length:
Max. cutting capacity:
Wood:
Steel:
Non-ferrous metal:
Metal pipe:
Battery pack: PSSAP 20-Li A1-1
Type:
Cells:
Rated voltage:
Capacity
Energy value:
Noise emission value:
Noise measurement value is determined in
accordance with EN60745. The rated noise level
of the power tool is typically as follow:
Sound pressure level (L
pA
Sound power level (L
WA
20 V
n 0–3000 min
-1
0
22 mm
150 mm
12 mm
18 mm
100 mm
Lithium ion
10
max. 20 V
5.0 Ah
90 Wh
) = 86.8 dB (A), K =3 dB
pA
) = 97.8 dB(A); K =3 dB
WA
Vibration values determined in accordance
with EN 60745:
Vibration (a )
h
Sawing chipboard a
Sawing of timber beams a
Charger: PSSAP 20-Li A1-2
INPUT
Rated voltage: 100 - 240 V ~
Rated frequency: 50 - 60Hz
Rated power: 95 W
OUTPUT
Rated voltage: 14.4–20 V
Rated current: 4 A
Charging time: Approx. 45 min (2.5 Ah
battery pack)
Approx. 90 min (5.0 Ah
battery pack)
Protection class: II /
Wear hearing protection.
Note: The vibration level specified in these
instructions has been measured in accordance with
the standardised measuring procedures specified
and can be used to make equipment comparisons.
The specified vibration emission value can also be
used to make an initial exposure estimate.
WARNING! The vibration level varies in
accordance with the use of the power tool and may
be higher than the value specified in these
instructions in some cases. Regular use of the electric
tool in such a way may cause the user to
underestimate the vibration. Try to keep the vibration
loads as low possible. Measures to reduce the
vibration load are, e.g. wearing gloves and limiting
the working time. Wherein all states of operation
must be included (e.g. times when the power tool is
switched off and time where the power tool is
switched on but running without load)
= 11.926 m/s
h,B
= 12.392 m/s
h,WB
K=1.5 m/s
2
GB
2
2
7