Operation; Switching On And Off; Adjusting The Base Plate; Practical Tips - Parkside PSSAP 20-Li A1 Bedienungs- Und Sicherheitshinweise

CAUTION! - Battery pack
from the tool prior to changing the blade
Do not use any blunt, bent or damaged blade
Always install a suitable saw blade for the job.
1. Turn chuck ring
3
2. Insert saw blade
17
as per direction a.
2
3. Release chuck ring
original position
4. Pull the saw blade
is installed properly
Removing the saw blade:
1. Turn chuck ring
3
2. Pull the blade from saw blade retainer
17
as per direction b.
3. Release chuck ring
original position
Note: For certain work, the saw blade can also
be inserted after turning through 180°.

Operation

When working with the device, always wear
suitable clothing and appropriate protective
equipment.
Prior to each use it must be ensured that the
device is working correctly. Personal protective
equipment and a fully functional device reduce
the risk of injuries and accidents.
After the device has been switched off, the
blade continues moving for some time. Do not
touch the moving blade and do not attempt to
brake it. Danger of injury!

Switching on and off

Ensure your stance is stable and hold the tool's
front handle and rear handle
5
both hands. Before switching on the device,
ensure it is not in contact with the work piece.
must be removed
9
17
in anti-clockwise direction
into saw blade retainer
and let it turns back to
3
in direction b to check it
17
in anti-clockwise direction
, it will turn back to
3
firmly with
8
Switching on:
. 1. Ensure that battery pack
properly (see "Attaching / Disconnecting the
battery pack to / from the product").
2. Press the switch lock
(see Fig. H).
7
3. Then release switch lock
switch lock
position.
4. By using On / Off switch
progressively control stroke rate.
Gentle pressure : low stroke rate
Greater pressure : higher stroke rate
On/Off switch
2
Switching off:
Just release On / Off switch
Note: LED work light
about 10s right after tool is switched off
(On / Off switch

Adjusting the base plate

To adapt to the work piece, the base plate
be adjusted and swivelled to 4 positions.
Press the adjusting button
The base plate
desired position.
After base plate
position, press down base plate adjustment
button back to original position (see Fig. J).
13

Practical tips

Wear gloves when handling the
saw blade. In this way, you avoid
injury from cuts.
Caution: Risk of injury and damage to property!
- Do not use any blunt or bent blades or blades
which are damaged in any other way.
- Before sawing the work piece, check for hidden
foreign objects such as nails, screws. These
must be removed.
- Always insert a suitable saw blade.
- Secure the work piece with the aid of
clamping devices on the workbench.
is inserted
9
and On / Off switch
6
(see Fig. G). The
6
moves back into its original
6
, you can
7
cannot be locked
7
.
7
will keep on for
4
is released).
7
(see Fig. I).
13
can now be adjusted to the
1
is placed in desired
1
can
1
GB 13