Abicor Binzel ABITIG WH Serie Betriebsanleitung Seite 35

®
ABITIG WH
9.2 Cleaning the torch neck
9.3 Cleaning the changeable body
Fig. 7 Sharpening the tungsten electrode
To sharpen the tungsten electrode, use a sharpening device with a diamond
wheel. In doing so, observe the following:
• The point is sharpened longitudinally through the centre axis.
• Can be set for all electrode diameters.
• Offers continuous adjustment of the angle.
1 Remove gas nozzle.
2 Check wear parts for visible damage and replace them, if required.
3 Clean the separating point and grease O-rings with silicone-free sealing
grease.
4 Check the TCP after each use or after a collision in the WH alignment jig.
1 Clean coupling parts and slightly grease them with silicone-free sealing
grease.
2 Check clamp clip for visible damage and replace the complete changeable
body, if required.
NOTE
• Maintain the contact area between the torch neck and the changeable
body flat and free of soiling.
• When mounting the insulating jackets, make sure that no control leads
are caught between the two halves.
9 Maintenance and cleaning
20°
EN - 17